Spanish Codfish with sous-vide

Question

I recently made a Spanish codfish. It's called Bacalao al pil pil. The trick is to render the gelatin from the fish at a low temperature, reserve the fish meat and then mount the gelatin with oil. The whole process is somewhat longer.

The question is that codfish has a thick part and a thin part. So over/under cooking is always a problem. That's where I thought of the sous-vide technique. At what temperature could the fish be perfectly cooked and at the same time release all the gelatin?

Asked by BaffledCook

Answer

Per this paper, you want an extraction time of 15-60 mins at 113F / 45C. This patent uses temperatures below 131F / 55C. Both of those temperatures may be too low to make the cod actually taste good / cooked. 140F is a fairly typical temperature for sous vide fish. While 113F has some interesting results, it may or may not work for your dish as the result comes out quite different than standard cooked fish. However, I don't think that using a higher heat will have a negative effect on the gelatin extraction, so I'd start with 140F and work down from there.

This process may cause other problems though. In addition to extracting the gelatin, any other juices from the fish will mix with your gelatin. In a pan, these may steam off, but with sous vide you're stuck with them. I think you're likely to end up with a mixture that's much more watery than if you used a pan. You may find that this needs to be boiled down a little bit in order to get the desired consistency of your emulsion.

As always with sous vide, you've also got potential safety issues. You'll never reach pasteurization at 113F. You should check Douglas Baldwin's A Practical Guide To Sous Vide for cooking times (which are highly dependent on width).

Answered by yossarian

Check more discussion of this question.